The
K&N air filters for ATVs have the
highest flow in the industry giving you more power. They are also reusable
and way easier to clean then foam filters. More power, longer lasting.
Sounds good to us.

The Outerwears is a sock that goes
over the air filter made of a fine mesh material that repels water and other
fine dusts and debris. This outerwear will also allow you to run open air
box applications giving your ATV huge power gains in stage 2 and 3.

The Fuel Filter is not a power
upgrade but a precaution to long lasting engine life. This little sucker
will filter out any dirt or grime that may have passed through your gas
tank. Better safe then sorry.

Parking Block Off Plate are used to
remove the stock bulky crap that is stuck to your rear brake caliper. That
thing restricts your quad a bit and you'll definitely notice how much easier
it rolls after you install this cool little device. Every little bit helps.

Front Rocket Sprockets are easy to
install and can quickly curve your ATVs power in the direction you want it.
If you're looking for quicker acceleration you'll want to lower the amount
of teeth in your front sprocket. If you are looking for more top speed you
will want to add teeth to the front sprocket. These sprockets are usually
held on with 2 bolts and a sliding mechanism that locks it in. Pretty easy
to install and you'll need to adjust your chain to compensate for the larger
or smaller sprocket.

HMF Bill Ballance Full Exhaust is a no
compromise racing system designed for closed course motocross racing and woods
racing.  This is not a quiet pipe but with this power package it has a deep
growl to it that is just insane!  The huge open end cap in the back allows
for exhaust to escape quickly giving you that bottom end power that will rip
your arms off!

Wiseco 440 Big Bore Kit comes with the
new sleeve, (needs to be pressed in) piston (choose compression) rings, gasket,
and all the necessary hardware and clips you will need for installation. 
Please note that after installation you will need to break this motor in again
just as you did when the quad was brand new.

Dough Eichner Series 440 Carburetor is
designed specifically for this stage 3 440CC package.  Adjust your jetting
on the fly, get the serious flow your new motor craves, and most of all start
hurting your friends feelings that ride 450s.

Teather Pro Kill Switch wraps to your
wrist and to your handlebars / engine stop button in order to prevent your quad
from running if you happen to bust your ass.  Keep the rubber side down
fellas!  This kill switch is required for most races.

Magnum High Performance Clutch Kit is
needed to handle the extra power that your ATV is about to deliver.  You
can try to run the stock clutch kit for a little while but it's bound for
disaster.  Magnum Clutches are designed for high performance motors and
they bight really hard.

The Stage 2 Hot Cam's aggressive design
is specifically for motor cross and desert racing applications.  This big
lobed cam will have your power coming on hard and low so hold on.

Magnum Rev Boxes will safely push the
envelope when it comes to getting more power from more RPMs.  Sick of
hitting your stock rev limiter?  The Magnum Rev Box or sometimes called the
CDI box will allow you to rev higher and stronger.

• Normal Retail Costs


• K&N Air Filter - $57.95


• Outerwears - $17.95


• Fuel Filter - $3.50


• Parking Block Off Plate - $13.95


• Rocket Sprocket - $19.99


• Magnum Rev Box - $129.95


• Doug Eichner Series 440 Carburetor - 480.95 / 521.95(twist throttle)


• HMF Bill Ballance Full Exhaust - 479.95


• Wiseco 440CC big bore kit - 239.95


• Stage 2 hot Cam - $189.99


• Magnum Pro Teather Kill Switch - 32.99


• Magnum Clutch Kit - 99.95


• Normal Cost - Just under $1800


• Your Cost - $1499.99
  - FREE SHIPPING